(Pro/Auto/AutoPro)
This is where the floppy disk controllers are defined for
use with DiskDupe. If a drive is connected to a controller other than the
primary controller (for A: and B:) then the additional controller(s) must be
listed here. The primary controller is included on the Controller List by
default.
You can have DiskDupe automatically set up your controllers by pressing the
Auto-Set button or set them up manually by pressing Edit or Add. When you
press the Edit or Add button, DiskDupe brings up the Controller Setup
dialog box, where the controllers can be manually defined.
If you are manually adding a controller to this list and you are not sure what
type of controller you have, try setting the type as Standard, the
DMA to 2 and the IRQ to 6. Primary controllers are always at address 3F0 and
almost all secondary controllers are at address 370.
If your computer locks up when the Auto-Set button is pressed, there is
probably a card in the computer (such as a network card) that is using one
of the floppy disk controller addresses. In this case the additional
controllers should be added to the Controller List manually.
