(Auto/AutoPro)
The drive in the autoloader corresponds to a drive letter. Which letter it is
depends on the controllers in your system and how you connect the drive. If
you have a secondary controller like the CompatiCard IV, the autoloader drive
will be D:, if connected to a cable with a twist, or E:, if connected to a
straight cable. Otherwise it will probably be the B: drive.
If you have an autoloader attached to the B: drive, you would normally set
CMOS for A:&B: to No. This allows you to change drives in the autoloader
without having to reset the CMOS configuration each time.
Enter the drive that the autoloader is in at the Drive Setup, which is found
under Setup|Drive. Press Add to get to the Drive Setup window.
Whenever you use this drive as the Source or Destination, DiskDupe will
recognize it as an autoloader drive and know to duplicate automatically.
Notes:
- You will get an error if you try to copy to or from a drive that is not
attached to an autoloader. Select None for the Autoloader Drive if you
want to use a drive without the autoloader.
- When using A: or B: as the Autoloader Drive, and the autoloader is off at
the time the computer is booted up, your system may give you an error message
that the drive is not connected properly. This will not cause any problems
using the drive with DiskDupe.
